ASTM D8235-2018用作汽车火花点火发动机燃料的混合了汽油的乙基叔丁基醚规格Standard Specification for Ethyl Tertiary-Butyl Ether (ETBE) for Blending with Gasolines for Use as Automotive Spark-Ignition Engine Fuel
- 标准类别:
- 标准大小:
- 标准编号:ASTM D8235-2018
- 标准状态:现行
- 更新时间:2023-04-21
- 下载次数:次
1.1 This specification covers requirements for fuel grade ethyl tertiary-butyl ether (ETBE) utilized as a blend component at the 1 % to 22 % by volume for use as automotive spark-ignition engine fuel covered by Specifications D4814 and D8076 as well as other automotive fuel applications involving ETBE.
1.1.1 Other ETBE grades may be available for blending that are not covered by this specification. Specification D7618 is also available from ASTM International.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The following applies to all specified limits in this standard: For purposes of determining conformance with these specifications, an observed value or a calculated value shall be rounded “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding method of Practice E29. All digits expressed in the specification limits are to be considered significant digits.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-04-21
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-04-21
-
GB/T 706-2016热轧型钢 2023-04-21
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-04-21
-
JB/T 10216-2013电控配电用电缆桥架 2023-04-21
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-04-21
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-04-21
-
JTG D20-2017公路路线设计规范 2023-04-21