ASTM F2102-2017外科植入物用超高分子量聚乙烯加工样式氧化程度的评定指南Standard Guide for Evaluating the Extent of Oxidation in Polyethylene Fabricated Forms Intended for Surgical Implants
- 标准类别:
- 标准大小:
- 标准编号:ASTM F2102-2017
- 标准状态:现行
- 更新时间:2023-04-23
- 下载次数:次
1.1 This guide covers a method for the measurement of the relative extent of oxidation present in HDPE homopolymers and ultra-high-molecular-weight polyethylene (UHMWPE) intended for use in medical implants. The material is analyzed by infrared spectroscopy. The intensity (area) of the carbonyl absorptions (>C=O) centered near 1720 cm-1 is related to the amount of chemically bound oxygen present in the material. Other forms of chemically bound oxygen (C-O-C, C-O-O-C, C-O-H, and so forth) are not captured by this guide. 1.2 Although this guide may give the investigator a means to compare the relative extent of carbonyl oxidation present in various UHMWPE samples, it is recognized that other forms of chemically bound oxygen may be important contributors to these materials' characteristics. 1.3 The applicability of the infrared method has been demonstrated by many literature reports. This particular method, using the intensity (area) of the C-H absorption centered near 1370 cm-1 to normalize for the sample’s thickness, has been validated by an Interlaboratory Study (ILS) conducted according to Practice E691. FIG. 1 Typical FTIR Spectra of Oxidized UHMWPE, Showing the Definition of an Area-Based Oxidation Index Based on Normalization Using the 1370-cm-1 Peak FIG. 2 FTIR Spectra Showing the Carbonyl Absorption Bands Note 1: Note that both reagents effectively extracted the lipids (the lipid absorption peak is centered at approximately 1740 cm-1). The tibial insert was fabricated from highly crosslinked and remelted UHMWPE followed by terminal sterilization in EtO gas (Ref. 1). 1.4 The following precautionary caveat pertains only to the test method portion, Section 5, of this specification: This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this s
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-04-23
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-04-23
-
GB/T 706-2016热轧型钢 2023-04-23
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-04-23
-
JB/T 10216-2013电控配电用电缆桥架 2023-04-23
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-04-23
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-04-23
-
JTG D20-2017公路路线设计规范 2023-04-23