ASTM D2712-2017 用气相色谱法测定丙烯浓缩物中痕量烃的试验方法 Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography ASTM D2712-2017 用气相色谱法测定丙烯浓缩物中痕量烃的试验方法 Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography

ASTM D2712-2017 用气相色谱法测定丙烯浓缩物中痕量烃的试验方法 Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography

  • 标准类别:
  • 标准大小:
  • 标准编号:ASTM D2712-2017
  • 标准状态:现行
  • 更新时间:2023-05-01
  • 下载次数:
标准简介

1.1 This test method is used for the determination of hydrocarbon impurities in Propylene (propene) material of 97 % by mass or greater purity (concentrates). These impurities are determined in the concentration range of 0.35 mg/kg to 8575 mg/kg and includes the following components, methane, ethane, ethylene, propane, acetylene, isobutane, propadiene, normal butane, trans-2-butene, butene-1, isobutylene, cis-2-butene, isopentane, methylacetylene, normal pentane, and 1,3-butadiene. Note 1: Optionally, the analysis may include the determination of pentenes/hexanes and heavier components, see 6.3. 1.2 This method does not determine non-hydrocarbon impurities, and additional tests may be necessary to fully characterize the propylene sample. However, for the purposes of this test, the purity of propylene is determined as the difference between the total of the determined analytes and 100 % (by difference). 1.3 When this method is being used for the determination of trace level impurities in high-purity propylene, the use of this method for the analysis of propylene samples at lower purities is not recommended due to the potential for cross contamination between samples. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued

标准截图