ASTM E3119-2017 受环境控制动力载荷加速时效试验方法 Standard Test Method for Accelerated Aging of Environmentally Controlled Dynamic Glazing ASTM E3119-2017 受环境控制动力载荷加速时效试验方法 Standard Test Method for Accelerated Aging of Environmentally Controlled Dynamic Glazing

ASTM E3119-2017 受环境控制动力载荷加速时效试验方法 Standard Test Method for Accelerated Aging of Environmentally Controlled Dynamic Glazing

  • 标准类别:
  • 标准大小:
  • 标准编号:ASTM E3119-2017
  • 标准状态:现行
  • 更新时间:2023-05-17
  • 下载次数:
标准简介

1.1 This test method covers the accelerated aging and monitoring of the time-dependent performance of environmentally controlled dynamic glazings such as thermochromic (TC) thermotropic, photochromic glazings. and combinations thereof. 1.2 The test method is applicable only for environmentally controlled dynamic glazings. These glazings may be either monolithic glass, monolithic laminated glass, or sealed insulating glass units fabricated for use in buildings, such as exterior doors, windows, skylights, and wall systems. 1.3 During use, the environmentally controlled dynamic glazings tested according to this method are exposed to environmental conditions, including solar radiation and are employed to control the amount of transmitted radiation by absorption and reflection and thus, limit the amount of solar radiation that is transmitted into a building. 1.4 The test method is not applicable to electronically controlled chromogenic devices, such as electrochromic devices. 1.5 The test method is not applicable to environmentally controlled dynamic glazings that are constructed from superstrate or substrate materials other than glass. 1.6 The test method referenced herein is a laboratory test conducted under specified conditions. 1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the

标准截图
版权:如无特殊注明,文章转载自网络,侵权请联系cnmhg168#163.com删除!文件均为网友上传,仅供研究和学习使用,务必24小时内删除。