ASTM D1059-2017 基于短--长试样的纱线支数试验方法 Standard Test Method for Yarn Number Based on Short-Length Specimens
- 标准类别:
- 标准大小:
- 标准编号:ASTM D1059-2017
- 标准状态:现行
- 更新时间:2023-06-08
- 下载次数:次
1.1 This test method covers the determination of the yarn number of all types of cotton, woolen, worsted, and man-made fiber yarns taken from packages; or from any textile fabrics in which the yarns are intact and can be removed in measurable lengths. The test method is not applicable to yarns taken from napped or cut pile fabrics. Because this test method is based on short-length specimens, the results should only be considered as approximations of yarn number. Note 1: For a more precise procedure for the determination of yarn number, refer to Test Method D1907. Note 2: The following additional methods for the determination of yarn number have been approved for yarns made from specific fibers: Specification D541, D578, and D681. 1.2 This test method is applicable to yarns which stretch less than 5 % when tension on yarn is increased from 0.25 to 0.75 cN/tex (0.25 to 0.75 gf/tex). By mutual agreement it may be adapted to yarns which stretch more than 5 % by use of tension lower than that specified in the method for elastomers or use of tension higher than that specified in the method to pull the crimp out of textured yarns. 1.3 The values stated in SI units are to be regarded as standard; the values in inch-pound units are reported as information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-06-08
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-06-08
-
GB/T 706-2016热轧型钢 2023-06-08
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-06-08
-
JB/T 10216-2013电控配电用电缆桥架 2023-06-08
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-06-08
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-06-08
-
JTG D20-2017公路路线设计规范 2023-06-08