ASTM D1126-2017 水硬度测试方法 Standard Test Method for Hardness in Water
- 标准类别:
- 标准大小:
- 标准编号:ASTM D1126-2017
- 标准状态:现行
- 更新时间:2023-06-13
- 下载次数:次
1.1 This test method covers the determination of hardness in water by titration. This test method is applicable to waters that are clear in appearance and free of chemicals that will complex calcium or magnesium. The lower detection limit of this test method is approximately 2 to 5 mg/L as CaCO3; the upper limit can be extended to all concentrations by sample dilution. It is possible to differentiate between hardness due to calcium ions and that due to magnesium ions by this test method. 1.2 This test method was tested on reagent water only. It is the user's responsibility to ensure the validity of the test method for waters of untested matrices. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-06-13
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-06-13
-
GB/T 706-2016热轧型钢 2023-06-13
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-06-13
-
JB/T 10216-2013电控配电用电缆桥架 2023-06-13
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-06-13
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-06-13
-
JTG D20-2017公路路线设计规范 2023-06-13