ASTM C957/C957M-2017 带整体磨损面、高固体含量、冷液涂敷的弹性防水膜的规格 Standard Specification for High-Solids Content,Cold Liquid-Applied Elastomeric Waterproofing Membrane With Integral Wearing Surface
- 标准类别:
- 标准大小:
- 标准编号:ASTM C957/C957M-2017
- 标准状态:现行
- 更新时间:2023-06-20
- 下载次数:次
1.1 This specification describes the required properties and test methods for a cold liquid-applied elastomeric membrane for waterproofing building decks not subject to hydrostatic pressure. The specification applies only to a membrane system that has an integral wearing surface. This specification does not include specific requirements for skid resistance or fire retardance, although both may be important in specific uses. 1.2 The type of membrane system described in this specification is used for pedestrian and vehicular traffic and in high-abrasion applications. The membrane may be single- or multi-component, and may consist of one or more coats (for example base coat, top coat, etc.). The coat(s) may be built to the desired thickness in one or more applications. One coat (base coat) provides the primary waterproofing function and normally comprises the major amount of organic material in the membrane. The function of the top coat(s) is to resist wear and weather. Aggregate may be used as a component of the membrane system, as all or part of a course, to increase wear and skid resistance. 1.3 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations. 1.4 Test methods in this specification require a minimum 0.5-mm [0.020-in.] base coat dry film thickness. Actual thickness required for a particular application and the use of aggregate in topcoats shall be established by the membrane manufacturer. 1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.6 The following safety hazards caveat pertains only to the test method portion, Section 5, of this specification: This standard does not purport
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-06-20
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-06-20
-
GB/T 706-2016热轧型钢 2023-06-20
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-06-20
-
JB/T 10216-2013电控配电用电缆桥架 2023-06-20
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-06-20
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-06-20
-
JTG D20-2017公路路线设计规范 2023-06-20