ASTM D2517-2018 增强环氧树脂气压管及配件规格 Standard Specification for Reinforced Epoxy Resin Gas Pressure Pipe and Fittings
- 标准类别:
- 标准大小:
- 标准编号:ASTM D2517-2018
- 标准状态:现行
- 更新时间:2023-06-27
- 下载次数:次
1.1 This specification covers requirements and methods of test for materials, dimensions and tolerances, hydrostatic-burst strength, chemical resistance, and longitudinal tensile properties, for reinforced epoxy resin pipe and fittings for use in gas mains and services for direct burial and insertion applications. The pipe and fittings covered by this specification are intended for use in the distribution of natural gas, petroleum fuels (propane–air and propane–butane vapor mixtures), manufactured and mixed gases where resistance to gas permeation, toughness, resistance to corrosion, aging, and deterioration from water, gas, and gas additives are required. Methods of marking are also given. Design considerations are discussed in Appendix X1. 1.2 The values in SI units are to be regarded as the standard. 1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this standard. 1.4 A recommended inplant quality control program is given in Appendix X2. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-06-27
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-06-27
-
GB/T 706-2016热轧型钢 2023-06-27
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-06-27
-
JB/T 10216-2013电控配电用电缆桥架 2023-06-27
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-06-27
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-06-27
-
JTG D20-2017公路路线设计规范 2023-06-27