ASTM A841/A841M-2017 用热机械控制工艺(TMCP)生产的压力容器用中厚钢板的规格 Standard Specification for Steel Plates for Pressure Vessels,Produced by Thermo-Mechanical Control Process (TMCP)
- 标准类别:
- 标准大小:
- 标准编号:ASTM A841/A841M-2017
- 标准状态:现行
- 更新时间:2023-07-14
- 下载次数:次
1.1 This specification2 covers steel plates produced by the thermo-mechanical control process (TMCP). The plates are intended primarily for use in welded pressure vessels. A description of the TMCP method is given in Appendix X1. 1.2 Due to the inherent characteristics of the TMCP method, the plates cannot be formed at elevated temperatures without sustaining significant losses in strength and toughness. Except for Grade G, the plates may be formed and post-weld heat-treated at temperatures not exceeding 1200°F [650°C], providing the requirements of 6.1 are met. Grade G plates may be formed at temperatures not exceeding 985°F [530°C] provided the requirements of 6.1 are met. 1.3 The maximum permitted nominal thickness of plates furnished to this specification is 4 in. [100 mm] for Grades A, B, and C; 1.5 in. [40 mm] for Grades D,3 E, and F; and 2 in. [50 mm] for Grade G. 1.4 Grade G is susceptible to magnetization. Use of magnets in handling after heat treatment should be avoided if residual magnetism would be detrimental to subsequent fabrication or service. 1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-07-14
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-07-14
-
GB/T 706-2016热轧型钢 2023-07-14
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-07-14
-
JB/T 10216-2013电控配电用电缆桥架 2023-07-14
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-07-14
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-07-14
-
JTG D20-2017公路路线设计规范 2023-07-14