ASTM A662/A662M-2017 中低温用碳-锰-硅钢压力容器中厚板的规格 Standard Specification for Pressure Vessel Plates,Carbon-Manganese-Silicon Steel,for Moderate and Lower Temperature Service
- 标准类别:
- 标准大小:
- 标准编号:ASTM A662/A662M-2017
- 标准状态:现行
- 更新时间:2023-07-18
- 下载次数:次
1.1 This specification2 covers three grades of carbon-manganese-silicon steel plates intended primarily for service in welded pressure vessels where improved low temperature notch toughness is important. 1.2 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements. 1.3 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply. 1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-07-18
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-07-18
-
GB/T 706-2016热轧型钢 2023-07-18
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-07-18
-
JB/T 10216-2013电控配电用电缆桥架 2023-07-18
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-07-18
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-07-18
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2023-07-18