ASTM D5185-2018 用感应耦合等离子体原子发射光谱法测定用过和用过润滑油及基础油中多种元素的试验方法 Standard Test Method for Multielement Determination of Used and Unused Lubricating Oils and Base Oils by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES)
- 标准类别:
- 标准大小:
- 标准编号:ASTM D5185-2018
- 标准状态:现行
- 更新时间:2023-07-19
- 下载次数:次
1.1 This test method covers the determination of additive elements, wear metals, and contaminants in used and unused lubricating oils and base oils by inductively coupled plasma atomic emission spectrometry (ICP-AES). The specific elements are listed in Table 1. (A) These wavelengths are only suggested and do not represent all possible choices. 1.2 This test method covers the determination of selected elements, listed in Table 1, in re-refined and virgin base oils. 1.3 For analysis of any element using wavelengths below 190 nm, a vacuum or inert-gas optical path is required. The determination of sodium and potassium is not possible on some instruments having a limited spectral range. 1.4 This test method uses oil-soluble metals for calibration and does not purport to quantitatively determine insoluble particulates. Analytical results are particle size dependent, and low results are obtained for particles larger than a few micrometers.2 1.5 Elements present at concentrations above the upper limit of the calibration curves can be determined with additional, appropriate dilutions and with no degradation of precision. 1.6 For elements other than calcium, sulfur, and zinc, the low limits listed in Table 2 and Table 3 were estimated to be ten times the repeatability standard deviation. For calcium, sulfur, and zinc, the low limits represent the lowest concentrations tested in the interlaboratory study. (A) where: X = mean concentration, μg/g. (A) where: X = mean concentration, μg/g. 1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determ
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-07-19
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-07-19
-
GB/T 706-2016热轧型钢 2023-07-19
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-07-19
-
JB/T 10216-2013电控配电用电缆桥架 2023-07-19
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-07-19
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-07-19
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2023-07-19