AS 5144.2-2018 工业卡车--安全要求和验证--第2部分:自行式可升降式卡车 Industrial trucks - Safety requirements and verification - Self-propelled variable-reach trucks (ISO 3691-2:2016, MOD)

This part of ISO 3691 gives safety requirements and the means for their verification for self-propelled
industrial variable-reach trucks and variable-reach container handlers/reach stackers as defined in
ISO 5053-1 (hereafter referred to as trucks), equipped with forks or integral load-handling devices for normal industrial duties (e.g. fork arms or means, such as spreaders, for handling containers).
It is not applicable to
- rough-terrain variable-reach trucks,
- rough-terrain variable-reach trucks for handling containers,
- machines designed primarily for earth-moving (e.g. loaders and dozers), even when their buckets
and blades are replaced with forks,
- machines from which the load can swing freely in all directions.
For the purposes of this part of ISO 3691, fork arms and integrated attachments are considered to be
a part of the truck, whereas attachments/equipment mounted on the load carrier or on the fork arms
which are removable by the user are not. Nevertheless, requirements for such attachments are also
given by the document.
Any regional requirements additional to the provisions of this part of ISO 3691 are addressed in
ISO/TS 3691-7 and ISO/TS 3691-8.
This part of ISO 3691 deals with all significant hazards, hazardous situations or hazardous events, as
listed in Annex B, with the exception of the following, relevant to the applicable machines when used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer.
It does not establish requirements for hazards that can occur
- during construction,
- when using trucks on public roads,
- when operating in potentially explosive atmospheres, or
- when lifting persons. AS 5144.2:2018 a A r A N N O r M a\- Australian 7j\ STANDARD Industrial trucks-Safety requirements and verification Part 2: Self-propelled variable-reach trucks (ISO 3691-2:2016, MOD) AS 5144.2:2018 This Australian Standard？ was prepared by ME-026, Industrial Trucks. It was approved on behalf of the Council of Standards Australia on 20 September 2018. This Standard was published on 29 October 201