ASTM D8265-2019 已安装土工膜泄漏电气方法规程 Standard Practices for Electrical Methods for Mapping Leaks in Installed Geomembranes
- 标准类别:
- 标准大小:
- 标准编号:ASTM D8265-2019
- 标准状态:现行
- 更新时间:2023-08-04
- 下载次数:次
1.1 These practices describe standard procedures for using electrical methods to locate leaks in geomembranes covered with liquid or earthen materials, which can be watered to cause leakage through the geomembrane. For clarity, these practices use the term “leak” to mean holes, punctures, tears, knife cuts, seam defects, cracks, and similar breaches in an installed geomembrane (as defined in 3.2.7).
1.2 These practices are intended to ensure that leak location surveys are performed to the highest technical capability of electrical methods, which should result in complete liquid containment (no leaks in geomembrane).
1.3 Not all sites will be easily amenable to this method, but some preparation can be performed in order to enable this method at nearly any site.
1.4 The geomembrane must be covered with water or as wet as practical. Earthen materials or sludge, or both, may also be present over the geomembrane. The main requirement is that a hydraulic gradient exist across the geomembrane so that if a hole or breach exists in the geomembrane, it will actively leak during the testing. If ideal testing conditions cannot be achieved, the method can still be performed, but any issues with site conditions are documented.
1.5 Leak location surveys can be used on geomembranes installed in basins, ponds, tanks, ore and waste pads, landfill cells, landfill caps, and other containment facilities. The procedures are applicable f
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-08-04
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-08-04
-
GB/T 706-2016热轧型钢 2023-08-04
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-08-04
-
JB/T 10216-2013电控配电用电缆桥架 2023-08-04
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-08-04
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-08-04
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2023-08-04