首页 > 标准下载>ASTM D5319-2017 玻璃纤维增强聚酯墙和顶板规格 Standard Specification for Glass-Fiber Reinforced Polyester Wall and Ceiling Panels免费下载
ASTM D5319-2017 玻璃纤维增强聚酯墙和顶板规格 Standard Specification for Glass-Fiber Reinforced Polyester Wall and Ceiling Panels ASTM D5319-2017 玻璃纤维增强聚酯墙和顶板规格 Standard Specification for Glass-Fiber Reinforced Polyester Wall and Ceiling Panels

ASTM D5319-2017 玻璃纤维增强聚酯墙和顶板规格 Standard Specification for Glass-Fiber Reinforced Polyester Wall and Ceiling Panels

  • 标准类别:
  • 标准大小:
  • 标准编号:ASTM D5319-2017
  • 标准状态:现行
  • 更新时间:2023-09-13
  • 下载次数:
标准简介

1.1 This specification covers the classification, materials of construction, workmanship, physical requirements, and methods of testing glass-fiber-reinforced polyester composite wall and ceiling panels intended for use in light construction and semi-structural applications. 1.2 Supplementary information on chemical resistance, impact resistance, and installation practice are provided in Appendix X1. 1.3 The classification of these composite panels into classes based on relative response to a laboratory test shall not be considered a fire-hazard classification. 1.4 Laboratory flammability tests (Test Methods E84 and D1929) applicable to this specification should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or conditions. However, results may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. 1.5 The intent of this specification is to define the class, grade, and general laminate properties of the composite wall and ceiling liner panels in order to ensure a quality product which will perform in the intended application. This specification is not intended to restrict or limit technological changes affecting performance when changes are agreed upon between the purchaser and manufacturer. 1.6 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only. 1.7 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in Tables and Figures) shall not be considered as requirements of this specification. 1.8 This standard does not purport to address all of the safety co

标准截图
下一条:返回列表
版权:如无特殊注明,文章转载自网络,侵权请联系cnmhg168#163.com删除!文件均为网友上传,仅供研究和学习使用,务必24小时内删除。