ASTM D2444-2019 用落锤试验法测定热塑性塑料管和配件耐冲击性的试验方法 Standard Practice for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
- 标准类别:
- 标准大小:
- 标准编号:ASTM D2444-2019
- 标准状态:现行
- 更新时间:2023-09-20
- 下载次数:次
1.1 This practice covers the determination of the impact resistance of thermoplastic pipe and fittings under specified conditions of impact by means of a tup (falling weight). Three interchangeable striking noses are used on the tup, differing in geometrical configuration. Two specimen holders are described.
Note 1: Appendix X1 shows the procedure to determine impact strength.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-09-20
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-09-20
-
GB/T 706-2016热轧型钢 2023-09-20
-
JB/T 10216-2013电控配电用电缆桥架 2023-09-20
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-09-20
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-09-20
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2023-09-20
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-09-20