ISO 19085-4-2018 木工机械--安全--第4部分:立式面板圆锯机 Woodworking machines — Safety — Part 4: Vertical panel circular sawing machines
- 标准类别:
- 标准大小:
- 标准编号:ISO 19085-4-2018
- 标准状态:现行
- 更新时间:2023-10-16
- 下载次数:次
This document gives the safety requirements and measures for manually loaded and unloaded
stationary vertical panel sawing machines, hereinafter referred to as “machines”.
NOTE 1 In manual loading, the operator puts the work-piece directly onto the work-piece support, with no intermediate loading device to receive and transfer the work-piece from the operator to the cutting position. In manual unloading, the operator removes the work-piece directly from the work-piece support, with no intermediate unloading device to transfer the work-piece from the cutting position to the operator.
It deals with all significant hazards, hazardous situations and events as listed in Clause 4 relevant to machines, when operated, adjusted and maintained as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse. Also, transport, assembly, dismantling, disabling and scrapping phases are taken into account.
NOTE 2 For relevant but not significant hazards, e.g. sharp edges of the machine frame, see ISO 12100:2010.
It is also applicable to machines fitted with one or more of the following devices/additional working units, whose hazards have been dealt with:
— an integrated feed device;
— a device for scoring;
— an angle cutting device;
— a middle support device;
— programmable end stops for parallel vertical cuts;
— a device for grooving with a width of at most 20 mm in one pass by using a milling tool; and
— a panel pusher.st edition
2018-02
Woodworking machines — Safety —
Part 4:
Vertical panel circular sawing
machines
Machines à bois — Sécurité —
Partie 4: Scies circulaires à panneaux verticales
Reference number
ISO 19085-4:2018(E)
?
ISO 2018
ISO 19085-4:2018(E)
COPYRIGHT PROTECTED DOCUMENT
? ISO 2018
All rights reserved. Unless otherwise specified, or required in the
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-10-16
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-10-16
-
GB/T 706-2016热轧型钢 2023-10-16
-
JB/T 10216-2013电控配电用电缆桥架 2023-10-16
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-10-16
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-10-16
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2023-10-16
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-10-16