ISO/TR 17243-2-2017 机床主轴--通过测量主轴箱来评价机床主轴的振动--第2部分:直接驱动的锭子和皮带传动的锭子,滚动轴承驱动器的主轴在600r/min和30000r/min之间的速度运行 Machine tool spindles — Evaluation of spindle vibrations by measurements on non-rotating parts — Part 2: Direct-driven spindles and belt-dr
- 标准类别:
- 标准大小:
- 标准编号:ISO/TR 17243-2-2017
- 标准状态:现行
- 更新时间:2024-01-13
- 下载次数:次
This document provides information on how to assess the severity of machine tool spindle vibrations measured on the spindle housing. It gives specific guidance for assessing the severity of vibration measured on the spindle housing at customer sites or at the machine tool manufacturer’s test facilities. Its vibration criteria apply to direct-driven spindles and belt-driven spindles intended for stationary machine tools with nominal operating speeds between 600 r/min and 30 000 r/min. It is applicable to those spindles of the rolling element bearing types only, to spindles assembled on metal cutting machine tools, and for testing, periodic verification, and continuous monitoring. It does not address
— geometrical accuracy of axes of rotation (see ISO 230-7),
— unacceptable cutting performance with regards to surface finish and accuracy,
— vibration severity issues of machine tool spindles operating at speeds below 600 r/min or exceeding 30 000 r/min (due to lack of supporting vibration data and limitations in many vibration measurement instruments), or
— frequency domain analyses such as fast Fourier transform (FFT) analyses, envelope analyses or other similar techniques.
Annex A presents an introduction to alternative bearing condition assessment techniques.st edition
2017-08
Machine tool spindles — Evaluation of
spindle vibrations by measurements
on non-rotating parts —
Part 2:
Direct-driven spindles and belt-driven
spindles with rolling element bearings
operating at speeds between 600 r/
min and 30 000 r/min
Broches pour machines-outils — évaluation des vibrations des
broches par mesurage sur les parties non tournantes —
Partie 2: Broches à entra?nement direct et broches à entra?nement
par courroie à roulements à billes opérant à des vitesses
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2024-01-13
-
GB/T 706-2016热轧型钢 2024-01-13
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2024-01-13
-
JB/T 10216-2013电控配电用电缆桥架 2024-01-13
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2024-01-13
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2024-01-13
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2024-01-13
-
YB/T 4001.1-2019钢格栅板及配套件 第1部分:钢格栅板 2024-01-13
-
GB 51251-2017建筑防烟排烟系统技术标准 2024-01-13