ISO 11119-3-2020 气瓶--可再充气复合气瓶和管道的设计、建造和试验--第3部分:带非共载金属或非金属衬垫或不带衬垫的450升以下的全包裹纤维增强复合气瓶和管道 Gas cylinders — Design, construction and testing of refillable composite gas cylinders and tubes — Part 3: Fully wrapped fibre reinforced composite gas cyl
- 标准类别:
- 标准大小:
- 标准编号:ISO 11119-3-2020
- 标准状态:现行
- 更新时间:2024-01-30
- 下载次数:次
This document specifies minimum requirements for the material, design, construction and
workmanship, manufacturing processes, examination and testing at time of manufacture for:
— type 4 composite fully wrapped cylinders or tubes with a non-load sharing liner and composite
reinforcement on both the cylindrical portion and the dome ends;
— type 5 fully wrapped cylinders or tubes without liners and with a test pressure of less than 60 bar
and composite reinforcement on both the cylindrical portion and the dome ends;
— water capacities up to 450 l;
— for the storage and conveyance of compressed or liquefied gases;
— cylinders and tubes with composite reinforcement of carbon fibre, aramid fibre or glass fibre (or a
mixture thereof) within a matrix;
— a minimum design life of 15 years.
Cylinders and tubes manufactured and tested according to this document are not intended to contain
toxic, oxidizing or corrosive gases.
This document does not address the design, fitting and performance of removable protective sleeves.
NOTE 1 References to cylinders in this document include composite tubes if appropriate.
NOTE 2 ISO 11439 applies to cylinders intended for use as fuel containers on natural gas vehicles and
ISO 11623 covers periodic inspection and re-testing of composite cylinders.rd edition
2020-11
Gas cylinders — Design, construction
and testing of refillable composite gas
cylinders and tubes —
Part 3:
Fully wrapped fibre reinforced
composite gas cylinders and tubes
up to 450 l with non-load-sharing
metallic or non-metallic liners or
without liners
Bouteilles à gaz — Conception, construction et essais des tubes et
bouteilles à gaz rechargeables en matériau composite —
Partie 3: Tubes et bouteilles à gaz entièrement bobinés en matériau
composite renforcés de fibres
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2024-01-30
-
GB/T 706-2016热轧型钢 2024-01-30
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2024-01-30
-
JB/T 10216-2013电控配电用电缆桥架 2024-01-30
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2024-01-30
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2024-01-30
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2024-01-30
-
YB/T 4001.1-2019钢格栅板及配套件 第1部分:钢格栅板 2024-01-30
-
GB 51251-2017建筑防烟排烟系统技术标准 2024-01-30