ASTM E648-2017 用辐射热能源测定地面覆盖系统临界辐射通量的试验方法 Standard Test Method for Critical Radiant Flux of Floor-Covering Systems Using a Radiant Heat Energy Source
- 标准类别:
- 标准大小:
- 标准编号:ASTM E648-2017
- 标准状态:现行
- 更新时间:2023-08-09
- 下载次数:次
1.1 This fire-test-response standard covers a procedure for measuring the critical radiant flux of horizontally mounted floor-covering systems exposed to a flaming ignition source in a graded radiant heat energy environment in a test chamber. A specimen is mounted over underlayment, a simulated concrete structural floor, bonded to a simulated structural floor, or otherwise mounted in a typical and representative way. 1.2 This fire-test-response standard measures the critical radiant flux at flame-out. It provides a basis for estimating one aspect of fire exposure behavior for floor-covering systems. The imposed radiant flux simulates the thermal radiation levels likely to impinge on the floors of a building whose upper surfaces are heated by flames or hot gases, or both, from a fully developed fire in an adjacent room or compartment. The standard was developed to simulate an important fire exposure component of fires that develop in corridors or exitways of buildings and is not intended for routine use in estimating flame spread behavior of floor covering in building areas other than corridors or exitways. See Appendix X1 for information on proper application and interpretation of experimental results from use of this test. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of this standard. 1.5 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions but does not by itself incorporate all factors required for fire-hazard or fire-risk assessment of materials, products, or assemblies under actual fire conditions. 1.6 This standard does not purport to address al
-
GB 30871-2022免费下载危险化学品企业特殊作业安全规范 2023-08-09
-
GB/T 1094.1-2013电力变压器 第1部分:总则 2023-08-09
-
GB/T 706-2016热轧型钢 2023-08-09
-
GB 9706.1-2020医用电气设备 第1部分:基本安全和基本性能的通用要求 2023-08-09
-
JB/T 10216-2013电控配电用电缆桥架 2023-08-09
-
GB/T 10801.2-2018绝热用挤塑聚苯乙烯泡沫塑料(XPS) 2023-08-09
-
GB 51251-2017建筑防烟排烟系统技术标准 2023-08-09
-
GB/T 13663.2-2018给水用聚乙烯(PE)管道系统 第2部分:管材 2023-08-09