首页 > 资料下载 > 先进的燃烧后CO2捕集Advanced Post-Combustion CO2 Capture
先进的燃烧后CO2捕集Advanced Post-Combustion CO2 Capture 先进的燃烧后CO2捕集Advanced Post-Combustion CO2 Capture

先进的燃烧后CO2捕集Advanced Post-Combustion CO2 Capture

  • 资料类别：
  • 资料大小：
  • 资料编号：
  • 资料状态：
  • 更新时间：2021-09-18
  • 下载次数：次
会员下载(2点)
VIP会员下载(0点)
游客扫码下载(2点)
资料简介

从发电厂的烟气中分离和捕获CO2的想法没有实现。 源于对气候变化的关注。相反，它得到了尽可能多的关注。 廉价的CO2源，尤其用于提高采收率（EOR）作业 其中将CO2注入油藏以增加油的流动性，从而， 水库的生产率。几家商业性植物从 发电厂烟气是美国70年代末80年代初建设的。什么时候？ 石油价格在上世纪80年代中期下降，回收的二氧化碳对于提高采收率来说太贵了。 行动，迫使这些捕获设施关闭。然而，塞尔斯谷 美国加州Trona的矿物厂，利用该工艺生产二氧化碳用于碳酸化 卤水，1978年开始运行，至今仍在运行。再捕获几次二氧化碳 随后建造了工厂，生产用于商业应用和市场的二氧化碳。

The idea of separating and capturing CO2 from the flue gas of power plants did not originate out of concern about climate change. Rather, it gained attention as a possible inexpensive source of CO2, especially for use in enhanced oil recovery (EOR) operations where CO2 is injected into oil reservoirs to increase the mobility of the oil and, thereby, the productivity of the reservoir. Several commercial plants that capture CO2 from a power plant flue gas were constructed in the late 1970s and early 1980s in the US. When the price of oil dropped in the mid-1980s, the recovered CO2 was too expensive for EOR operations, forcing the closure of these capture facilities. However, the Searles Valley Minerals Plant in Trona, CA, which uses this process to produce CO2 for carbonation of brine, started operation in 1978 and is still operating today. Several more CO2 capture plants were subsequently built to produce CO2 for commercial applications and markets.

资料截图
版权：如无特殊注明，文章转载自网络，侵权请联系cnmhg168#163.com删除！文件均为网友上传，仅供研究和学习使用，务必24小时内删除。
无法下载/下载错误/文件打不开/点这里
热门推荐