首页 > 资料下载 > 燃烧后捕获技术发展评价Assessment of Post-Combustion Capture Technology Developments
燃烧后捕获技术发展评价Assessment of Post-Combustion Capture Technology Developments 燃烧后捕获技术发展评价Assessment of Post-Combustion Capture Technology Developments

燃烧后捕获技术发展评价Assessment of Post-Combustion Capture Technology Developments

  • 资料类别：
  • 资料大小：
  • 资料编号：
  • 资料状态：
  • 更新时间：2021-09-22
  • 下载次数：次
会员下载(2点)
VIP会员下载(0点)
游客扫码下载(2点)
资料简介

有几种方法可以分离和捕获来自化石燃料发电厂的碳排放 烟气可分为三大类：预燃、含氧燃料和后燃。 燃烧。EPRI在所有这三个领域都有活跃的项目；然而，这份报告仅限于此 重点关注用于改造或新工厂应用的燃烧后捕获。 后燃烧过程在烟气排放之前立即在“尾端”处理烟气。 来自植物。此时，烟道气处于或接近大气压、温暖、饱和。 与水蒸气，并具有约12%的CO2含量。捕获系统的主要目标是 尽可能经济地从废气中去除高百分比的二氧化碳， 准备永久存放。

There are several ways to separate and capture carbon emissions from fossil fueled power plant flue gas which can be classified into three general categories: pre-combustion, oxyfuel and post- combustion. EPRI has active programs in all three of these areas; however, this report only focuses on post-combustion capture for retrofit or new plant applications. Post-combustion processes treat flue gas at the “tail-end,” immediately before it is exhausted from the plant. At this point, the flue gas is at or close to atmospheric pressure, warm, saturated with water vapor, and has a CO2 content of about 12%. The primary goal of a capture system is to remove a high percentage of carbon dioxide from the effluent gas as economic as possible, and to prepare it for permanent storage.

资料截图
版权：如无特殊注明，文章转载自网络，侵权请联系cnmhg168#163.com删除！文件均为网友上传，仅供研究和学习使用，务必24小时内删除。
无法下载/下载错误/文件打不开/点这里
热门推荐