A brief review of Fischer-Tropsch synthesis specially in slurry reactors ispresented,
covering reaction kinetics, activity and selectivity of catalysts, productdistribution, effects of process
parameters, mass transfer and solubility of gas. Someimportant aspects of further research are
proposed for improving both theories andproduction....
Ni-based catalysts doped with copper additives were studied on their role in ethanol steam reforming reaction.The effects of Ca content,support species involving Al2O3-SiO2,Al2O3-MgO,Al2O3-ZnO,and Al2O3-La2O3,on the catalytic performance were studied.Characterizations by TPR,XRD,NH3-TPD,XPS,and TGA indicated that catalysts 30Ni5Cu/Al2O3-MgO and 30NiSCu/Al2O3-ZnO have much higher H2 selectivity than 30NiSCu/Al2O3-SiO2,as well as good coke resistance.H2 selectivity for 30Ni5Cu/Al2O3-MgO catalyst was 73.3% at 450℃ and increased to 94.0% at 600 ℃,whereas for 30NiSCu/Al2O3-ZnO catalyst,the H2 selectivity was 63.6% at 450 ℃ and 95.2% at 600 ℃.These Al2O3-MgO and Al2O3-ZnO supported Ni-Cu bimetallic catalysts may have important applications in the production of hydrogen by ethanol steam reforming reactions....
Amide, which is derived from proline and is inexpensive and air-stable, has been synthesized and characterized by 1H NMR,13C NMR, and MS. It was found to be an efficient ligand in the palladium-catalyzed Suzuki cross-coupling reaction. In the Pd/amide catalytic system, aryl bromides can be coupled with phenylboronic acid in ethanol/water (1:2;v/v) in excellent yields even with a low Pd loading of 0.01 mol%. Moreover, the scope of the reaction is broad, and a wide variety of functional groups are tolerant....
Ethanol induced method was applied to prepare Cu-Fe-Zr catalysts for conversion of syngas to higher alcohols. The catalytic performance of the catalysts induced by ethanol was superior to that of the catalyst prepared by the conventional precipitation method. Among various procedures for ethanol induced method,it was found that incorporation of ethanol in the precipitation process was the better. After incorporation of ethanol,the crystal size of CuO decreased and the reduction of copper species became easier. The better activity of Cu-Fe-Zr catalysts prepared by ethanol induced procedures was probably caused by the higher dispersion of Cu species....
The partial oxidation of ethanol to hydrogen was investigated over Ni/Fe/La catalysts prepared by the co-precipitation method. The effects of introduction of La promoter and the reaction temperature on the catalytic performance were studied. It was found that the introduction of La into Ni/Fe catalysts is helpful to increase the selectivity to hydrogen and the stability of the catalysts. The results of XRD and XPS characterization show that the structure of the catalyst was changed during the reaction. The existence of LaFeO3 species is possibly the main reason of the increase of the catalyst stability....
There is abundant supply of light alkanes and relatively few routes of converting them to more valuable products. Although CH4 predominates in natural gas, it also contains C2H6, C3H8 and C4H10 (from 5 % to 30% ), and with C2H6 as the most abundant secondary component[1]. Partial oxidation of methane to syngas (CH4 +0.5O2 →CO + 2H2) over nickel-based catalysts has received intensive attention[2]and much research has been devoted to conversion of ethane to ethylene[3]. Ethylene has been shown to be formed from ethane by thermal dehydrogenation (C2H6 →C2H4 + H2) and oxidative dehydrogenation (C2H6 + 0. 5O2 →C2H4 + H2O). These processes are operated under severely fuel-rich conditions. The carbon-deposition and consequent deactivation of the catalysts are major problems, which leads to poor conversion of the above mentioned reactions. As an alternative strategy for the elaboration of ethane, little work on the partial oxidation of ethane (POE) to syngas over nickel-based catalysts has been reported. Provided it could be produced from C2H6with high selectivity and high conversion over nickel-based catalysts, syngas could be directly obtained from natural gas including CH4 and C2H6 with high selectivity and conversion. This may lead to better utilization of the light fractions from natural gas and refineries. In the present paper, POE to syngas over nickel-based catalysts was investigated....